Filter
Top Products
Search System
For each recording, an invisible index mark is placed on the tape. A program index and
information are also included for timer recordings. These marks are used to access or
scan recordings.
1
2
INDEX SEARCH
ENTER INDEX NUMBER :1
USING 1- 9 KEYS
FORWARD SEARCH:FF
REVERSE SEARCH :REW
NEXT :SEARCH
EXiT :STOP
Press SEARCH*
to display SEARCH
in Stop or Play
mode, and then
press NUMBER
keys
to select recording
number.
• To calculate
number, see below.
Press FF/SLOW+
or REW/SLOW- on
the remote to start
search.
INDEX SEARCH
FORWARDSEAROH :PF
REVERSESEARCH:REW
Play begins at
search end.
To search forward
or back 1 index,
press FF/SLOW+ or
REW/SLOW- on the
remote while
screen left is
displayed (10 sec.).
• To cancel, press
PLAY or STOP.
• To Calculate Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press REW.
Example 2:
To go to rec. 6 from rec. 2, enter 4 and press FF.
NOTE: _ indicates start points of each recording.
Locates end point of recording for continuity.
Press SEARCH twice
to display SEARCH in Stop or Play
mode.
2 [ PROORAME"OSEARC"/
SEARCH START : FF
EXIT :SEARCN
Press FF/SLOW+
on the remote to
start PROG RAM
END SEARCH.
• To cancel, press
PLAY or STOP.
Examples of Program End Search.
the current ta e osrtion
Pros_BEAR__o.on End Point
FF
the current t e pos)tion
Press S EAI_I _1button
_[ { FP _[If search exceedsl
End Point r/a few seconds in [
[BLANK area. ]
Upon locating end point,
-_ search continues 7 sec. past end point,
-_ tape rewinds to 10 sec. before end point,
-_ tape plays to end point and steps.
O
• If Index Search is started very close to an • If Program End Search is started very close to
index mark, that index mark may not be an index mark, that mark may be skipped over.
counted in the search,
30