Filter
Top Products
• If your TV has AUDIO and VIDEO IN terminals, connect them to DECK for higher
quality picture and sound.
• You can enjoy stereo sound even if your TV is not stereo by connecting a stereo
amplifier to DECK.
• Connect DECK and TV with an RF Coaxial Cable (_) (supplied) or an AV Cable (_
(not supplied) as shown in the figure below.
• DSSReceiver=kDECK=kTV • DECK.I, TV
Antenna or Cable
• Cable Box .I,DECK.I_TV
DSS
Receiver CableBox
D VD/VCR DECK
L O VHF/UHF
AUDIO OUTTOTV
R ©
Disconnect antenna or cable from TV
and connect to DECK.
2 Connect DECK to TV wffh RF Coaxial Cable.
RF COAXIAL CABLE
VHF/
AUDIOIN
R L IN
A V CABLE (not supptied)
rw'""'"° I
When using "Nut type" RF coaxial cables, tighten with
damage terminals.Overtightening may
fingers only.
Note to CABLE system installer
This reminder is provided to call the CABLE system installer's attention to Article 820-40 of the
NEC in USA (and to the Canadian Electrical Code in Canada) that provides guidelines for proper
grounding and, in particular, specifies that the cable ground shall be connected to the grounding
system of the building, as close to the point of cable entry as practical.