Filter
Top Products
15
RQT8157
∫ Component video output
Component signal outputs the colour difference signals (PB/PR) and luminance signal (Y) separately in order to achieve high fidelity in
reproducing colours. If the television is compatible with progressive output, a high quality picture can be output because this unit’s component
video output terminal outputs a progressive output signal (➡ 65).
Connecting a television with S VIDEO or COMPONENT VIDEO terminals
∫ Connecting to a television with 21-pin Scart
terminal
You can also connect with the AV1 terminal on this unit using
the 21-pin Scart cable.
If your television is equipped with RGB input capability, by
connecting with a fully wired 21-pin Scart cable you can see
video using RGB output on this unit.
To output in RGB select “RGB (without component)” from “AV1
Output” in the SETUP menu (➡ 55).
RGB refers to the three primary colours of light, red (R), green
(G), and blue (B) and also the method of producing video that
uses them. By dividing the video signal into the three colours for
transmission, noise is reduced for even higher quality images.
∫ Connecting to a VCR with 21-pin Scart
terminal
You can also connect with the AV2 terminal on this unit using
the 21-pin Scart cable.
To input in RGB select “RGB/Video” or “RGB” from “AV2 Input”
in the SETUP menu (➡ 55).
COMPONENT
VIDEO IN
S VIDEO IN
AUDIO IN
R L
VIDEO IN
Y
P
B
PR
COMPONENTCOMPONENT
VIDEOVIDEO OUTOUT
(NTSC:480p/480i,(NTSC:480p/480i,
PAL:576p/576i)PAL:576p/576i)
OPTICALOPTICAL
DIGITAL AUDIO OUTDIGITAL AUDIO OUT
(PCM/BITSTREAM)(PCM/BITSTREAM)
AV4 IN AV4 IN OUTOUT
AUDIOAUDIO
VIDEOVIDEO
R
L
R
L
S VIDEO OUTS VIDEO OUT
S VIDEOS VIDEO
AV4 INAV4 IN
OUT
RF IN
COMPONENT
VIDEO IN
S VIDEO IN
AUDIO IN
R L
VIDEO IN
Y
P
B
P
R
COMPONENTCOMPONENT
VIDEOVIDEO OUTOUT
(NTSC:480p/480i,(NTSC:480p/480i,
PAL:576p/576i)PAL:576p/576i)
OPTICALOPTICAL
DIGITAL AUDIO OUTDIGITAL AUDIO OUT
(PCM/BITSTREAM)(PCM/BITSTREAM)
AV4 IN AV4 IN OUTOUT
AUDIOAUDIO
VIDEOVIDEO
R
L
R
L
S VIDEO OUTS VIDEO OUT
S VIDEOS VIDEO
AV4 INAV4 IN
RF OUT
RF IN
S VIDEO OUT terminal
Connect to S VIDEO IN terminal on the television
through a S Video cable.
The S VIDEO OUT terminal achieves a more vivid
picture than the VIDEO OUT terminal. (Actual results
depend on the television.)
COMPONENT VIDEO OUT terminal
Connect to COMPONENT VIDEO IN terminal on the
television through video cables. These terminals can be used
for either interlace or progressive output (➡ 65) and provide a
purer picture than the S VIDEO OUT terminal.
≥Connect to terminals of the same colour.
For progressive output (➡ 18)
Audio/
Video
cable
S Video
cable
Video cable
Audio/
Video
cable
Red
White
Ye l l o w
Red White Yellow
Red White Yellow
Yellow
White
Red
Television’s rear panel
Television’s rear panel
Note to owners of progressive compatible PAL system televisions (
➡
6)
STEP 1 Connection
EH50GN.book Page 15 Friday, March 4, 2005 2:36 PM