17
1
EN
Power supply
Power supply
Charging by connecting to a
computer via USB
You can charge the batteries by connecting
to a PC’s USB port. When charging, be sure
to correctly place the rechargeable batteries
(supplied) into the recorder (☞ P.15).
1 Boot the PC.
2 Connect the USB cable to the USB
port of the PC.
Do not charge primary batteries such
as alkaline or lithium batteries. It may
cause battery leakage or heating, which
may cause the recorder to malfunction.
Note
• When playing a voice/music file, the
recorder may be reset due to the
reduction of the voltage output of the
batteries depending on the volume level
even if [º] is displayed in the battery
indicator. In this case, lower the volume of
the recorder.
3 While the recorder is during stop
mode or turned off, connect
the USB cable to the connecting
terminal on the bottom of the
recorder.
4 Press the ` OK button to start
charging.
• While [Press OK to start charging] is
flashing, press the `OK button.
5
Charging is completed when battery
indication becomes to [
¿
].
Charging time: approximately 3 hours *
* It shows the approximate time when
charging the rechargeable battery
fully from no remaining power at the
room temperature. The charging time
Before connecting the USB cable,
exit HOLD mode (☞ P.21).