Filter
Top Products
20
Chapter 3, Installing Your Matrox MXO Software and Configuring Your System
4 Under Video Output Control, from the Set analog video as menu, select
the type of analog video output you want by selecting
Component, or
Composite & Y/C
.
5 Under Genlock Control, for Genlock source select one of the following:
$ Internal Select this to genlock to MXO’s internal reference signal. Select
this option only if you don’t have an external sync generator connected to
the REF IN on your MXO.
$ External Select this if you connected an external sync generator to the
REF IN on your MXO.
The status of your genlock source will be displayed next to
Genlock status
as Locked or Not Locked to indicate whether or not Matrox MXO is
presently locked to your genlock source.
6 If you select External as the genlock source, from the Genlock standard
menu, select your external genlock source’s video standard (this setting is
not applicable if you select
Internal as the genlock source).
¡ Important To ensure good output results, make sure that your genlock
source’s video standard matches the standard of your project.