Filter
Top Products
6
PROGRAM MODE
The Program Mode is laid out in a manner that allows you to program each
function separately, or you can follow the instructions entirely to program the
Weather Center. Complete programming is usually done for the initial set-up,
and will require you to skip step 1 of each programming section (from section
III to XI). The programming mode can be exited at any time by either pressing
the OUTDOOR button, or waiting for the 20-second time-out to take effect.
I. FUNCTION BUTTONS
There are 5 function buttons located on the front of the Weather Center,
under the LCD Screens. The function buttons are labeled: SET,
INDOOR, OUTDOOR, RAIN, and +.
II. SETTING THE LCD CONTRAST
1. Hold down the SET button for a second, the default setting
“LCD 5” will flash in LCD 1.
2. Press the + button to advance through the LCD settings. There are
8 settings to select from—“LCD 0” is the lightest and “LCD 7” is
the darkest.
3. Press the SET button to confirm, and to advance to select
12/24-hour time display.
III. 12/24-HOUR TIME DISPLAY SELECTION
1. Press the SET button twice to enter the 12/24-hour selection mode.
2. The default setting “24” will flash in LCD 1.
3. Use the + to select either “12” or “24” hour time display.
4. Press the SET button to confirm, and to advance to the Time
setting mode.
IV. TIME SETTING
Note:
The default time, after battery installation is “0:00” or “12:00.”
The Weather Center will begin to keep track of time after this.
1. Press the SET button three times to enter the Time setting mode.
2. The hour digit will flash in LCD 1.
3. Press the + button to advance the hours.
Note:
When setting the hours, notice that there is no “AM” icon to
indicate that the time being set is in the AM. There is only a “PM”
icon. Be sure to set the time accordingly.