Filter
Top Products
Filename [XVC37U_10Subsidiary.fm]
Masterpage:Left+
76 EN
Page 76 16 June 2004 5:54 pm
SUBSIDIARY SETTINGS (cont.)
* The default setting is bold in the table below.
8 AUTO SP]EP TIMER
ON
OFF
When this function is set to “ON”, the unit automatically switches to EP mode
to allow complete recording if there is not enough tape to record the entire
program while timer-recording in SP mode.
For Example:
Recording a program of 140 minutes in length onto a 120-minute tape
Make sure you set this function to “ON”, before the timer-recording starts.
NOTES:
● If you have programed the unit to timer-record 2 or more programs, the second
program and those thereafter may not fit on the tape if you set “AUTO SP]EP TIMER”
to “ON”. In this case, make sure the mode is not engaged, then set the tape speed
manually during timer programing.
● In order to ensure that the recording fits on the tape, this feature may leave a slight
non-recorded section at the end of the tape.
● There may be some noise and sound disturbance at the point on the tape where the unit
switches from SP to EP mode.
● The Auto SP
]EP Timer feature is not available during ITR (Instant Timer Recording),
and the feature will not work properly on the following tapes: T(ST)-30, T(ST)-60,
T(ST)-90, and T(ST)-120
8 VIDEO STABILIZER
ON
OFF
When this function is set to “ON”, you can automatically correct vertical
vibration in the picture when playing back unstable recordings made on
another recorder. If the vertical vibration does not improve, regardless of this
setting, try Manual Tracking (
੬ pg. 33). However, this function might have no
effect, depending on the recording condition of the tape.
NOTES:
● When you finish viewing a tape, be sure to set this function to “OFF”.
● Regardless of the setting, this function has no effect during recording and during special
effects playback.
● The on-screen display may jitter vertically when this function is set to “ON”.
8 BLUE BACK
ON
OFF
When this function is set to “ON”, the TV screen becomes all blue when
receiving a channel not in use.
NOTE:
When you want to receive an unstable channel with poor signals, set this function to
“OFF”.
Total 140 minutes
Approximately 110 minutes Approximately 30 minutes
SP mode EP mode
XVC37U_01.book Page 76 Thursday, June 17, 2004 9:18 AM