Filter
Top Products
Filename [XVC37U_09Editing.fm]
Masterpage:Left0
68 EN
Page 68 17 May 2004 8:44 pm
EDITING (VCR DECK)
Edit From A
Camcorder
You can use a camcorder as the source player and your
unit as the recording deck.
A
Make connections.
Connect the camcorder’s AUDIO OUT and VIDEO OUT
connectors to the unit’s front panel AUDIO and VIDEO
input connectors.
● When using a monaural camcorder, connect its AUDIO OUT
connector to the AUDIO L input connector on your unit.
B
Select the VCR deck.
On the unit
Press VCR/DVD repeatedly so that the VCR indicator
lights up.
On the Remote
Press VCR so that the VCR indicator lights up.
C
Set the unit’s input mode.
Press AUX (number key “0”) and/or CH to select “F-1”.
D
Set the edit mode.
See “PICTURE CONTROL” on page 75.
E
Engage the Record Pause mode.
Use PLAY (4), REW (3), or FF (5) to locate the
point where you start recording, then press and hold
PAUSE (9) and press REC (7) to engage the Record Pause
mode.
F
Start the camcorder.
Engage the Play mode of the camcorder.
G
Start the unit.
Press PLAY (4) to engage the Record mode of the unit.
NOTES:
● All necessary cables can be obtained from your dealer.
● When you select “EDIT” to dub tapes in step D, be sure to select
“NORM” after you finish dubbing the tapes.
Recorder
To AUDIO/VIDEO
Output connectors
AUDIO input
Player
VIDEO input
Audio/video cable
(not supplied)
Slide the TV/VCR/DVD switch to the right.
XVC37U_09Editing.fm Page 68 Monday, May 17, 2004 8:44 PM