Filter
Top Products
8
Installing the remote controller batteries
1. Remove the battery compartment cover by pressing
and sliding it away from the remote controller unit.
2. Insert two AA (R6- or UM-3)-size batteries into the
battery compartment. Carefully follow the polarity
diagram (positive (+) and negative (–) symbols)
inside the battery compartment.
3. After batteries are installed and seated correctly,
replace the compartment cover.
Notes:
• Do not mix new batteries with old batteries or
different kinds of batteries.
• To avoid corrosion, remove the batteries if the
remote controller is not to be used for a long time.
• Remove dead batteries immediately to avoid
damage from corrosion. If the remote controller
doesn’t operate smoothly, replace both the batteries
at the same time.
• The life of the batteries supplied is about six months
but this will vary depending on usage.
Using the remote controller
Point the remote controller toward the remote control
sensor.
Notes:
• Place the unit away from strong light such as direct
sunlight or inverted fluorescent light which can
prevent proper operation of the remote controller.
• Using another remote controller of the same type in
the same room or using the unit near equipment
which uses infrared rays may cause operational
interference.
• Do not put any object such as a book on the remote
controller. The buttons of the remote controller may
be pressed by mistake and drain the batteries.
• Make sure the audio rack doors do not have colored
glass. Placing the unit behind such doors may
prevent proper remote controller operation.
• If there is any obstacle between the remote control-
ler and the remote control sensor, the remote
controller will not operate.
Preparing the Remote Controller
DPC-6.1
Remote control sensor
approx. 5 m
(16 feet)
3
2
1
30
30
R
E
M
O
T
E
C
O
N
T
R
O
L
L
E
R
R
C
-
4
2
6
D
V