Filter
Top Products
Advanced Operations (Synchro Editing)
64
Insert the cassette you want to copy into VCR2.
On VCR2, press PLAY. Locate the place on the tape where you want to begin
copying, then press PAUSE.
Insert a cassette (with its safety tab intact) into VCR1. Put this VCR in RECORD-
PAUSE mode, and press AVX to put it in LINE mode.
Press PAUSE on VCR2 (the playback VCR) to start the recording. Both tapes will
start together.
Press PAUSE again on VCR2 when you want to stop. Both VCRs will pause.
Now fast-forward, rewind, or play the tape in VCR2 to find the next segment you want to
copy.
Put VCR2 into PLAY-PAUSE mode and press PAUSE again - recording will continue.
Press the STOP buttons on both VCRs when you are finished.
This procedure won't leave index marks unless you press STOP then REC between
sections recorded (more about index marks on page 32 and 35).
Programmable Easy Edit
Hookup when VCR1 is Recording
Hookup the two VCRs and the TV as shown on page 56.
Connect the synchro edit cable from EDIT on VCR1 to EDIT on VCR2. (see page 59)
Turn the power on to both VCRs and the TV, and select channel for VCR use.
Insert the cassette you want to copy into VCR2.
Insert a cassette (with its safety tab intact) into VCR1. Put this VCR in RECORD-
PAUSE mode, and press AVX to put it in LINE mode.
Programming Your Easy Edit
While aiming the remote control at the VCR, press the EDIT button on the remote.
The following menu appears: