Filter
Top Products
•
Pressing the no data (ND) key toggles data state on
or off.
•
Clearing an emergency (valid only if emergency
caused data off operation)
Exiting Data Calls
Under normal conditions, the radio enters the scan
lockout mode and returns to the control channel after
completion of a data call (transmit or receive). If, during
a data call, one of the following conditions occurs, the
data call is immediately terminated and the radio per-
forms the desired function:
•
PTT activated.
•
Emergency declared by pressing the pre-pro-
grammed emergency button.
•
A group or system change.
Scan Lockout Mode
Following the transmission or reception of a data call,
if scan is enabled, scanning will stop temporarily [two
independent pre-programmed times (after receive data
call and after transmit data call)]. During this time the
scan indicator will flash to indicate that scan is enabled
but temporarily suspended. This mode is normally exited
when the pre-programmed time expires; however, the
following actions will terminate the scan lockout mode
before the time-out is completed.
•
The clear button is pressed.
•
The PTT is pressed.
•
A group or system change.
75