Filter
Top Products
3.
When the working channel is assigned, and
are turned on and a short beep sounds indicat-
ing that communication can begin.
4. Hold the radio approximately three inches from the
mouth and speak in a normal voice into the micro-
phone (located between and on the
keypad).
5. Release the PTT button when the transmission is
complete and listen for a reply.
CONVENTIONAL FAILSOFT
In the unlikely event of a failure of the EDACS System,
communications may take place in conventional failsoft
mode. The radio will be automatically directed to a
communications channel set up for this purpose. During
this mode of operation, the control unit will display
CONV
FS
in the alphanumeric display. An increase in activity
on the channel during conventional failsoft operation may
be noticed, so be careful not to transmit until the channel
is clear.
Operation during conventional failsoft will be the
same as operation on a conventional system, except that
XMIT
BSY
If two or more tones, or a high pitched tone is
heard, the system may be busy and the call
request has been placed in queue or the request
has been denied for some reason. Refer to the
ALERT TONES section for more details.
NOTE
57