Filter
Top Products
12
Playing Compact Discs
NOTE: Although this CD player can read CD-R and CD-RW discs, in addition
to normal CDs, however the playability of CD-R/RW discs may be affected by
the type of software that was used to create the discs, as well as the quality
and condition of the blank media you are using. 100% playability cannot be
guaranteed. This is not an indication of a problem with the player.
Normal Playback
1.) Press the ALARM OFF/POWER button to switch the unit ‘On’. The POWER
LED indicator comes ‘On’.
2.) Press the CD PLAY/PAUSE button to enter CD playing mode.
3.) Press on the CD door in the area marked OPEN/CLOSE to open the door. If
you have not already done so, remove the ‘dummy CD’ transit protection card
from the CD player and discard it
4.) Place your disc on the center spindle with the printed label side facing up.
Press down near the center of the disc to make sure it is firmly ‘seated’ on the
spindle, press OPEN/CLOSE area to close the CD door.
5.) Two dashes “cd – –” flash while the player
reads the table of contents of the disc.
The display will show the total number
of tracks for a few seconds and then
return to the correct time.
To see the track number at any time during playback press the ALARM SET/
DISPLAY button. The track number will appear for several seconds and then
the display returns to the correct time.
NOTE: If the disc is inserted incorrectly, or if the disc is badly scratched
and cannot be read by the player,
“cd00” will appear on the display for a
few seconds, and then the display
returns to the correct time.
CKD1100_052107.p65 21/5/2007, 10:4412