Filter
Top Products
9
OPERATING INSTRUCTIONS
Setting The Correct Time And Day
NOTE: Connect the power cord to your AC outlet. Make sure to use an outlet
that is always ‘live’. Do not use an outlet that is controlled by a wall switch.
1.) When the unit is plugged in for the first
time, the clock display will begin
flashing “12:00” (AM).
2.) Depress and hold the CLK.ADJ/PROG.
button for at least two seconds until only
the Hour digits continue to flash.
3.) While the Hour digits are flashing press
the or buttons repeatly to set
the clock to the correct Hour. Be sure to
observe the PM indicator to set the hour
correctly.
If the PM indicator is ‘On’ the hour displayed is PM.
4.) When the correct hour is flashing, press
the CLK.ADJ/PROG. button again. The
Minute digits begin flashing.
5.) While the Minute digits are flashing
press the or buttons repeatly to
set the clock to the correct Minutes.
6.) Press the CLK.ADJ/PROG. button. The
Day indicator “d:1” begins to flash.
7.) While the day indicator is flashing, press
the or buttons repeatly to set
the display to the correct ‘Day’.
(1 = Monday, 2 = Tuesday, etc.)
CKD1100_052107.p65 21/5/2007, 10:449