Filter
Top Products
Chapter 8 Appendices
8.1 Inspections and Maintenance
8.1.1 PERIODIC PHYSICAL INSPECTIONS
Complete and thorough inspections should be done on a routine, periodic basis. The interval between
inspections and scope of the inspections will depend on the conditions of use. This interval must not exceed
1 year.
All mountings and enclosures should be visually examined for any condition that may affect mounting
integrity. A complete inspection should include, but not be limited to, looking for these types of damage to
DSAi Series modules and parts:
bends
breaks
broken parts
corrosion
cracks
cracks in welded joints
deformation
DANGER: Should any of the above listed types of damage exist, immediately remove the affected part from serv-
ice for repair or replacement. If there is any question about the integrity or capability of any mounting or rigging
part to perform its intended function, it must be immediately removed from service for repair or replacement.
8.1.2 PERFORMANCE TESTING
Listening tests and/or formal measurements should be done periodically. The interval between such tests will
depend on the frequency of system usage and the conditions of use. All transducers should be tested for
functionality and proper performance.
Careful listening will usually reveal transducer and/or enclosure problems in the form of distortion, buzzes,
rattles, or non-function.
8.1.3 CLEANING
The sides and rear of the enclosure function as a heat sink for the internal amplifiers. Because of this, they
must remain relatively free of dust and dirt to ensure good heat transfer to the surrounding air. If these
surfaces need cleaning, use a vacuum and/or damp cloth to remove any dust or dirt.
CAUTION: To avoid damaging the exterior finishes do not use cleaning solvents or abrasives.
33