Filter
Top Products
XDVD8285 OPERATION
29
ASP Config - Audio Settings
Notes:
Bass Freq
Treble Freq
Sub Filter
Sub Phase
Bass Q-Factor
These settings affect the quality of the audio in "Downmix" mode only and
are primarily for use by a professional installer. For the casual user, it is
recommended to only adjust the general sound quality by using the Audio Setup
Menu, which is accessed by pressing the SEL button on the remote or pressing
the rotary for 3 seconds.
Sets the bass center frequency for optimal bass effect.
Choices are 60, 80, 100, 130, 150 and 200Hz.
Sets the treble center frequency for optimal treble effect.
Choices are 10, 12.5, 15 and 17KHz.
Sets the subwoofer crossover frequency which affects the subwoofer’s low-pass
filter and the “SMALL” speakers’ high-pass filter.
Choices are 80, 120 and 160Hz.
Notes: This setting has no effect when the subwoofer is set to “OFF” and/or if any
other speaker is set to "LARGE".
Sets the phase of the subwoofer. Depending on the installation, this setting can
be used to change the relative phase of the subwoofer output in relation to the
other speakers.
Choices are 0˚ and 180˚.
This setting alters the sharpness or "Q factor" of the bass output.
Choices are 1.0, 1.25, 1.5 and 2.0.