Filter
Top Products
16
© 2005 Directed Electronics—all rights reserved
Li-Ion Battery Recharging
The PMP3520 comes with two Li-Ion rechargeable and removable batteries.
Charge the battery completely before using the PMP3520 for the first time by
following the steps below:
1. Connect the supplied AC Adapter to AC outlet, and plug in the other end of
the AC Adapter to the DC in-jack of the PMP3520.
2. While recharging, the power LED above the LCD screen will flash. If you turn
on the PMP3520 while recharging, you will see the power charging indica-
tion at the top of the LCD display.
3. When the battery is fully charged, the Power LED will stop flashing.
Disconnect the AC Adapter from the PMP3520.
NOTE: Charge the PMP3520 only with the supplied AC Adapter.
NOTE: Do NOT open the battery cap while power is on.
NOTE: The unit should not be left on the AC adapter for long periods of
time after battery is fully charged. This could damage the bat-
tery. The unit should be played on the internal battery until it
is completely drained. If the unit is turned off for a month,
charge the battery to retain full efficiency and life. The battery
should be completely charged before use when fully discharged,
new, or after not being used for a long period of time. Due to
the internal clock and IR sensor operation there is a continuous
battery drain even while the unit is off. The battery will dis-
charge when not being used.