Filter
Top Products
TIP PLACEMENT
1. Marking location of boom clamps: Mark the clamp
locations by starting at the center of the center boom section.
From this mark, locate 20 inch spaces to both ends of the
boom.
2. Fasten preassembled boom lines: Fasten the boom
clamps (#3) on the boom so the sprayer tip will be on the back
side of the boom. The wing extensions for the 60 foot boom are
1 inch tubing. Therefore, this boom will have two size clamps.
Page 8
- DF34NTL 3/4" Nozzle Elbow & Check Valve Assembly
- DF34NTT 3/4" Nozzle Tee & Check Valve Assembly
8. DF34T 3/4" Nozzle Tee
9. DF34E 3/4" Nozzle Elbow
10. DFB12 Nut
11. DFCP Spring Retainer Cap Assembly
12. DFDV Diaphragm (viton)
13. DFFD Floodjet Cap (red)
- DFFT Flat Cap (yellow)
14. DFGE Gasket (EPDM)
* ------ Tip (specify tip size) (not included)
REF. PART
NO. NO. DESCRIPTION
3/4" NOZZLE PARTS LIST
Please order replacement parts by PART NO. and DESCRIPTION.
3
1
3
2
10
14
*
13
8
9
12
11
DRIP FREE NOZZLES AND BOOM CLAMPS
- B11 114 1-1/4" Boom Clamp Assembly
1. 00068 1/4"-20UNC x 3/4" Hex Head Bolt
2. 00062 1/4"-20UNC Hex Nut
3. 00337 1-1/4" Boom Clamp
- 00338 1" Boom Clamp
REF. PART
NO. NO. DESCRIPTION
4
1-1/4" BOOM CLAMP PARTS LIST
4. NTL34 3/4" Nozzle Tee
5. NTT34 3/4" Nozzle Elbow
6. B12 Nut
* ------ Tip (specify tip size) (not included)
7. 8027 11/16" FPS Cap
REF. PART
NO. NO. DESCRIPTION
Please order replacement parts by PART NO. and DESCRIPTION.
3/4" NOZZLE PARTS LIST
3
3
1
2
*
7
6
5
CONVENTIONAL NOZZLES AND BOOM CLAMPS
Feeder Line Routing and Tip Placement for Outer HingeFeeder Line Routing and Tip Placement for Inner Hinge
- 340RB 3/4" Rubber Hose
- B12H 3/4" Gear Clamp
- NHT11 Nylon Hose Ties
Please order replacement parts by PART NO. and DESCRIPTION.
REF. PART
NO. NO. DESCRIPTION
BASIC PLUMBING PARTS LIST
NOTE: 40' Boom ...... 25 Tips
45' Boom ......27 Tips
50' Boom ...... 31 Tips(w/ 1" Ext.Tube)