Filter
Top Products
Mud Mount Kits for the TPS-6X-DSW Crestron MMK/WMKM-6X-DSW
CAUTION: Allow an air gap of at least 12 inches (30.48 cm) in the wall cavity
above and below the TPS-6X-DSW for heat dissipation.
1. Insert the two pins on one adjustment plate into the top two outer holes
on the mounting plate, as shown in the illustration below.
Create the Adjustment/Mounting Plate Assembly
ADJUSTMENT PLATE (2)
(2017631 )
MOUNTING PLATE
(2022811 )
PUSH ON FASTENER (4)
(2004121 )
2. Slide a push-on fastener over each pin on the adjustment plate to
loosely secure the adjustment plate and the mounting plate. Do not
push the push-on fasteners all the way down onto the pins. Slide them
on enough to keep the adjustment plate and mounting plate as one
adjustment/mounting plate assembly.
3. Use the second adjustment plate and repeat steps 1 and 2 using the
lower two holes on the mounting plate.
4. Locate an area on the wall that is free of miscellaneous wiring and
studs.
5. Make a small hole near the middle of the designated site; verify that the
location is suitable.
8 • Mud Mount Kits for the TPS-6X-DSW: MMK-6X-DSW & WMKM-6X-DSW Installation Guide – DOC. 6779A