Filter
Top Products
DETACHABLE VACUUM
ADAPTOR (Fig.7)
Always connect the vacuum
adaptor when sanding.
Remove the application tool
before mounting the vacuum
adaptor. To improve dust
extraction from the working
area, insert the dust-extraction
adaptor into the rear of the tool,
and connect the adaptor to a
dust-extraction system or a
suitable vacuum cleaner.
Fig. 7 I
ATTACHING THE APPLICATION TOOL (FIG. 8, 9, 10, 11)
A_, WARNING: Failure to remove the battery pack from the tool when
assembling parts, making adjustments, or changing accessories could result in
accidental starting causing possibly serious injury.
_, CAUTION: For all work or when changing application tools, always wear
protective gloves. The sharp edges of the application tools will cause personal
injury. Application tools can be very hot while working.
_, WARNING: Check that the application tools are correctly attached. Incorrect
or insecurely fastened application tools can come loose during operation and
cause a hazard.
_, WARNING: Do not attach the circular saw blade or the straight edge cutting
blade facing backwards (Fig. 8), as operation in this position may cause
serious injury.
1. Remove the battery pack from the Multi-Tool.
2. Loosen the flange bolt with the hex key provided. (Fig. 9)
3. Ensure that the inner threads and the drive shaft are clean.
4. Align the grooves on the application tool with the four raised ribs on the
drive shaft; put the application tool onto the drive shaft. (Fig.10)
5. With your gloved hand holding the blade, put on and tighten the flange bolt
using the hex key.
NOTE: Attach the application tool at the desired orientation for the task at hand.
The shaft is configured so that the application tool can be attached every 30°
around the shaft, from 0°to 330 ° (Fig. 11).
61199 ManuaLRevised_09 0310 Page 19