Filter
Top Products
TO DETACH BATTERY
PACK (Fig. 4)
1. Make sure that the tool
is "OFF"
2.
Depress the battery release
buttons located on the both
sides of th of the battery
pack to release the
battery pack.
3. Pull the battery pack out
and remove it from the tool.
A_, CAUTION: When placing
the battery pack in the tool,
be sure that the raised rib on
battery pack aligns with the
groove inside the tool and that
the latches snap into place
properly. Improper assembly
of the battery pack can cause
damage to internal components.
_, WARNING: Battery tools are
always in operating condition;
therefore, the direction-of-
rotation selector should always
be locked when not in use or
carrying the tool at your side.
ON/OFF SWITCH (Fig. 5)
To turn the tool ON, push the
on/off switch forward. To turn it
OFF, push the switch backward.
LED WORKLIGHT (Fig. 6)
The LED worklight, located
on the front of the tool, will
illuminate when the on/
off switch is in the forward
(ON) position. This provides
additional light on the surface of
the workpiece for operation in
lower-light conditions. The LED
worklight will turn off when the
switch is slid backwards (OFF).
Fig. 4
Fig. 5
Fig. 6
61199 Manual_Revised_09 0310 Page 18