Clarion VRX585USB MP3 Player User Manual


 
62
English
Owner’s manual
61
English
Owner’s manual
11-5 Cautions On Wiring
Be sure to turn the power off before wiring. Be particularly careful where you route the wires.
Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.
If the fuse should blow, check to see if the wiring is correct. If it is, replace the fuse with a new one
with the same amperage rating as the original.
To replace the fuse, remove the old fuse of the power supply lead and insert the new One.
Power supply lead for the Battery lead : 15A FUSE
There are various types of fuse holder. Do not let the battery side touch other metal parts.
After the connection, fix the lead by a clamp or insulation tape for protection.
Fuse
Fuse holder
11-4 Main Unit Installation (Fixed Mount)
(TOYOTA, NISSAN and other ISO/DIN
equipped vehicles)
: The screws with this mark are enclosed in this set.
: The parts and screws with this mark are used to install radio or included in the installation kit.
Note 1 : In some cases, the center panel may require some modification (trimming, filling, etc.).
Note 2 : If a hook on the installation bracket interferes with the unit, bend and flatten it with a nipper
or a similar tool.
This unit is designed for fixed installation in the dashboard.
If the vehicle is equipped with a factory-installed radio, install the main unit with the parts and
screws marked (*).
If the vehicle is not equipped with a factory-installed radio, obtain an installation kit to install the
main unit in the following procedure.
(1) Bend all of side stoppers with a nipper.
(2) Secure the mounting brackets to the chassis as shownin the follow figure. Holes are pre-tapped
for TOYOTA and NISSAN vehicles; modification, such as drilling new holes, of the mounting
brackets may be required for other models.
(3) Wire as shown in chapter 11-6.
(4) Secure the unit in the dashboard, and then reassemble the dashboard and the center panel.
4-Hexagonal screw
(M5 x 8)
Center Panel
(Note1)
Note 2
Pocket
Main
Unit
Mounting bracket
(1 pair for the left and right sides)