Filter
Top Products
LTO
LTO
TM
4
CONNECTING THE RM2 TO THE UCS PRO
Ensure power to the UCS PRO and the rest of the audio system is .
At each side of the panel of the UCS PRO that carries the 25-pin connector, remove the bolts securing the
cover of the UCS PRO*. You will need a suitable Allen key to remove these bolts.
( The top cover of the UCS PRO may also be completely removed, rotated 180 degrees and refitted so that
the inscription faces forward. We recommend your dealer does this for you).
A D-SUB 25-pin male terminal on the UCS PRO mates with the recessed 25-pin female socket on the rear of
the UCSPRO-RM2 Programmer. The connectors are shaped in such a way that they will fit together only
when correctly aligned.
Line-up the two terminals carefully and then gently exert even pressure, bringing both parts together so that
the terminals mate correctly.
DO NOT APPLY EXCESSIVE FORCE.
There should be no need to apply more than moderate pressure when bringing the two devices together. The
extended side panels of the UCSPRO-RM2 will help to correctly align the two devices.
The two devices should fit together without a gap between them, and the fixing holes should align at each
side. Secure the RM2 to the UCS PRO by bolting the extended side panels of the RM2 to the sides of the
UCS PRO using the mounting bolts provided.
switched OFF
*