Filter
Top Products
LTO
LTO
TM
17
Refer to the details under Input Equalization - the available parameters are identical.
Pressing NEXT steps through each of the available EQ bands for Output 1, and then Output 2, and so on to
Output 6. Press ESC to quit this mode.
The UCS PRO has no analog output gain controls - gain adjustment is handled
entirely in the digital domain. The maximum signal level that can be handled by the D/A converters is 2.2V.
Select MODE NEXT x5 . Press ENTER.
Now you can set the level for Output 1 (OP1) in 0.5dB steps between 30.0dB and 6.0dB by adjusting the
rotary control.
Press NEXT and repeat the procedure above for the other Outputs.
Press ESC to quit this mode.
It is important to optimize the Input and Output Gain settings of the UCS PRO to ideally match the output from
your car audio head unit and the input stage of your power amplifier(s). The optimum settings will ensure the
lowest possible noise and no distortion.
While set-up by ear is possible, the best results will require use of a voltmeter and oscilloscope, and this is
therefore generally best left to a professional installer.
The signal phase of each output channel can be set at (in phase) or
(180 degrees out of phase).
Select MODE NEXT x6 Press ENTER. Use the rotary control to select or
. Use NEXT to select each Output Channel. Press ESC to quit this mode.
Output Gain (Edit Menu):
Output Polarity (Edit Menu):
Edit Output Gain
Normal
Reverse
Edit Output Pol. Normal
Reverse
This can be useful for quickly correcting reverse-wired speakers or improving overall phase alignment in
multi-speaker installations. This feature becomes especially powerful when combined with the fine control
available via the Crossover section, allowing full 360 degree phase adjustment in 5 degree steps.
Parameter & Functions Set-up Guide