12
SCANTEAM 6920 User’s Guide
Setting a Prefix (preamble) Character
1. Turn off power to the host PC.
2. Set MSR DIP switch position 8 to OFF.
3. Turn on power to the host PC.
4. Type the following keys: UBExxxxx;<ENTER>
- where x" is:
any lower case letter (a to z),
any number (0 to 9),
any Function key (F1 through F12), or
the ESC, SPACE, CR, [, ], or TAB keys.
Note: .“;“ must be typed after the prefix characters are entered. Up to
five prefix characters may be assigned.
5. Turn off power to the host PC.
6. Set MSR DIP switch position 8 to ON.
7. Reapply power to the host PC.
Setting a Suffix (postamble) Character
Use the same procedure as setting a prefix" to activate and set
a suffix (postamble). The keystrokes (at step 4) are:
UEExxxxx;<ENTER>
Setting the Position of a Prefix (preamble) or a Suffix (postamble) in data
Use the same procedure as setting a prefix" to set the position
of a prefix (preamble) or suffix (postamble) in the data sent to
the host PC. The keystrokes (at step 4) are:
UPE<ENTER> to send the prefix before and the suffix
after each track
UPD<ENTER> to send the prefix before and the suffix
after all tracks.
Deactivating and Eliminating a Prefix (preamble) or a Suffix (postamble)
Use the same procedure as setting a prefix" to deactivate and
eliminate a prefix (preamble) or suffix (postamble). The
keystrokes (at step 4) are:
UBD<ENTER> to disable the prefix (preamble) or
UED<ENTER> to disable the suffix (postamble).
