A SERVICE OF

logo

8
SCANTEAM 6920 User’s Guide
Dip Switch Feature Selection
Parameter
Lower & Upper
Case Control
Setting
SW 1
Configurations
Always Upper Case
OFF*
Keyboard Control
ON
Keyboard Type
Setting
SW 2
AT
OFF*
XT-PS/2 models
25/30/70
ON
SS, ES Code
Setting
SW 3
Enabled
OFF*
Disabled
ON
Carriage Return
Setting
Setting
SW 4
CR None
ON
After Each
Track
ON*
Keystroke Speed
Characters per second
Setting
SW 6
80 C/S
OFF*
25 C/S
ON
Output Type
(Factory Set)
Setting
SW 7
Reserved
OFF*
Mode
Setting
SW 8
Normal Operating
ON*
Keyboard Programming
OFF
SW 5
After All
Tracks
OFF
Reserved
OFF
ON OFF*ON OFF
➂➃
Notes:
Asterisk (*) Indicates Factory Default Setting.
Use this configuration if your PS/2 uses AT type keyboard scan
codes.
When using XT Mode, SW 1 must be set ON.
This DIP switch setting value can be changed in Keyboard
Programming Mode. See “Using Keyboard Programming
Mode to Set Keyboard Type,” page 10.
This DIP switch setting value can be changed in Keyboard
Programming Mode. See “Using Keyboard Programming
Mode to Set Keystroke Speed,” page 9.
See page 9 for information about using the “Keyboard
Programming” Mode switch (SW8).