English
Chapter 7 - Troubleshooting 87
mode is used. Printing on the photo side is unreli-
able.
10 Are you using home-made cards or thick cards?
Cards with thickness within the range of 0.07 mm
- 0.23 mm (0.003" - 0.01") can be used in manual
feed mode.
11 Are there pages piled up near the output slot or in
the output paper tray?
When printed material obstructs the paper output
slot, the paper feed and paper output may not
work correctly.
12 Have you loosened the paper sufficiently prior to
loading it into the sheet feeder?
Paper must be riffled several times prior to being
loaded into the sheet feeder. If not, sheets of
paper may stick to one another and cause multiple
sheets to feed into the printer at the same time, or
other forms of misfeed.
The printer emits unusual noises when the power
is turned on, and the error lights blink
1 Has the carriage packing material been
removed?
Refer to Chapter 1, Introduction for details on
removing packing material.
2 Has the packing tape been removed?
There are two pieces of tape on the front of the
printer that help protect the printer during ship-
ping. Gently remove the tape before using the
printer.
3 Has a cartridge become dislodged from the
cartridge holder?
Open the front cover and make sure the cartridges
are correctly installed.
4 Is there a paper jam?
Clear a paper jam by refering to ‘Clearing Paper
Jams’ in this Chapter. Occasionally a small piece
of paper will tear off and remain in the printer. If
this happens, hold the release lever down and use
a thick piece of paper to remove the small piece
of paper.
