74 User’s Guide
9 Is the cut corner in the correct position (for
transparencies and back print film)?
When these sheets are inserted with the cut corner
incorrectly positioned, they may not feed cor-
rectly. Follow the instructions and insert the
sheets correctly.
10 Are you printing on envelopes, thermal paper, or
picture cards?
Correct printing and feeding of envelopes and
thermal paper cannot be guaranteed. The paper
side of picture cards can be used if the card is less
than 0.23 mm (0.01") thick and manual feed
mode is used. Printing on the photo side is unreli-
able.
11 Are you using home-made cards or thick cards?
Cards with thickness within the range of 0.07 mm
- 0.23 mm (0.003" - 0.01") can only be used in
manual feed mode.
12 Is there anything blocking the paper output slot
(such as a large pile of printed sheets)?
This can cause ejection or feed problems, remove
the blocking paper.
13 Have you loosened the paper sufficiently prior to
loading it into the sheet feeder?
Paper must be riffled several times prior to being
loaded into the sheet feeder. If not, sheets of
paper may stick to one another and cause multiple
sheets to feed into the printer at the same time, or
other forms of misfeed.
Printer emits unusual noises when the power is
turned on, and the error lights blink
1 Has the carriage packing material been
removed?
Refer to Chapter 1, Introduction for details on
removing packing material.
2 Has the packing tape on the case been removed?
There are two pieces of tape on the front of the
printer that help protect the printer during ship-
ping. These must be removed before using the
printer.
3 Has an ink cartridge become dislodged from the
carriage?
Open the front cover and make sure the ink car-
tridges are correctly installed.
