18
Setting the audio [Audio]
This unit is equipped with a sound quality adjusting function
which allows users to enjoy the desired playback sound quality.
•This setting remains eective even if the power is turned o.
Noise Shaper
Digital feedback is used to improve the low-sound linearity and
the noise characteristics of the audible band.
Although no dierence is observed in the measured values,
the sound quality is changed, allowing users to specify a
favorite sound quality.
1
Press MENU.
Turns on the Menu settings mode
and the Menu appears on the
display (vpage 11 “Menu
map”).
2
Use ui to select “Audio” –
“Noise Shaper”, then press
ENTER or p.
“Noise Shaper” menu appears.
3
Use ui to select “On” or “O”, then press ENTER
or p.
The setting is entered.
NOTE
The Noise Shaper function is disabled during playback of a 32
kHz sampling frequency source and DSD.
DC Filter
This filter is eective in preventing excessive speaker vibration
when playing music source where audio with extremely low
noise characteristics has been recorded. (The cut frequency is
set at 1.7 Hz.)
1
Press MENU.
Turns on the Menu settings mode
and the Menu appears on the
display (vpage 11 “Menu
map”).
2
Use ui to select “Audio” – “DC
Filter”, then press ENTER or p.
“DC Filter” menu appears.
3
Use ui to select “On” or “O”, then press ENTER
or p.
The setting is entered.
NOTE
•The DC Filter function is disabled during playback of a 32 kHz
sampling frequency source and DSD.
•The “Noise Shaper”, “DC Filter” and filter characteristics
have a last memory function. These settings remain in
memory even if the power is turned o.
Digital Out (Setting for the digital output)
1
Press MENU.
Turns on the Menu settings mode
and the Menu appears on the
display (vpage 11 “Menu
map”).
2
Use ui to select “Audio” –
“Digital Out”, then press ENTER
or p.
“Digital Out” menu appears.
3
Use ui to select “On” or “O”, then press ENTER
or p.
•When “Digital Out” is set to “O”, the digital out o
indicator lights on the display.
