13
n Update on web screen
Firmware can be updated using the “Web control function”
(vpage39).
“Web control function” (vpage 39) settings must
be completed in advance on a PC belonging to the same
network.
For information on obtaining update files, please contact
our customer service center.
1
Click r from step 5 for the “Web control function”
(vpage39).
The PC will display the following screen.
Wait for approximately 1 minute.
You can also gain access by entering the IP address
shown by the unit into a web browser.
Please wait for a minute...
FIRMWARE
GThe web displayH
GThe unit’s screen displayH
2
When the following screen is displayed by the PC,
click the “Choose File” (q) button, select the update
file, and click the “Upload” (w) button.
Firmware
Upload new firmware
Upload
Choose File
q
w
General Settings [General]
3
When the following screen is displayed, click the
“OK” (e) button.
Updating will begin.
Firmware
Warning
Once started,the upload process cannot be interrupted or adorted,
in order to ensure the integrity of the Digital Media Player.
Are you sure you want to proceed?
OK
e
NOTE
Do not operate the unit while updating is in progress.
4
When the following screen is displayed, updating is
complete.
Firmware
New Firmware:
xxx.fw
Firmware upload status: 100% completed.
The upload process finished successfully.
Please close this.
Button names may vary depending on the OS language used
on your computer.
n Notification
Update
Displays a notification message on this unit’s menu screen
when the latest firmware is released with “Update”.
Connect to broadband Internet (vpage 8) when using
this function.
1
Press MENU.
Turns on the Menu settings mode
and the Menu appears on the
display (vpage 11 “Menu
map”).
2
Use ui and ENTER to select
“General” – “Firmware” –
“Notification” – “Update”, then
press ENTER or p.
“Update Notification” menu
appears.
3
Use ui to select “On”, then press ENTER or p.
On
Display update message.
O
Do not display update message.
•When you press ENTER during display of the notification
message, the “Check For Update” is displayed. (Refer to
page12 for more information on “Update”.)
•Press
o to erase the notification message.
