96 U23841-J-Z915-6-76
Administering hosts Configuring Xprint V7.0
Not all the possible options for each command can be described in this
chapter but only the most important ones. For more detailed information
see the description of the relevant command in the “Xprint V7.0 -
Reference Manual”.
For every command, you can call online help with the -? option. This
online help works on two levels: command and option level.
If you call help on command level, the general form of this command will
be displayed. This type of help displays the objects supported by the
command. It also shows the options which are independent of the object
type. Not all the options are displayed, however, as these depend on the
use of a command and object together. To call online help on command
level, enter xpadd -?, for example.
Option level help displays all the possible options of a specific object
type. To call the online help on option level, you must specify the
xpadd -dgr -? command, for example.
6.1 Administering hosts
This section deals with the Xprint V7.0 objects of type host which must first be
edited for new computers in an Xprint V7.0 configuration. The following table
serves as a guide through this section:
6.1.1 Configuring the first host
Configuring Xprint V7.0 on a stand-alone system and configuring the first host
in a network only requires a few steps. This is in most cases done by one
person, who is referred to below as the Xprint V7.0 administrator. This section
is only intended for the Xprint V7.0 administrator. The Xprint V7.0 administrator
may be someone who is only responsible for managing Xprint V7.0 or he/she
If you want to... Read...
configure Xprint V7.0 on the first host
in a network or on a stand-alone
system
section “Configuring the first host” on
page 96
configure Xprint V7.0 on a new host section “Configuring a new host” on
page 98
Table 8: Administering hosts
i
