9
6. Attach Reflector Studs to the top of the Head
Assembly (C). Insert 1 Reflector Stud through 1 Large Flat
Washer and into hole on the top of the Head Assembly (C).
Tighten stud securely. Repeat with the other 2 Reflector Studs.
Hardware Used: 3 x Reflector Stud
3 x Large Flat Washer
7. Attach Head Assembly (C) to Upper Post (F).
Route Gas Hose (E) down into Upper/Lower post assembly
and align 4 small holes on Head Assembly with 4 Small holes
in Upper Post (F).
[HINT: Control knob should be above decal on post.]
Loosen and remove the 4 Small Bolts w/Lock Washers
that are pre-assembled on the Head Assembly (C) and re-insert
them into the holes in the Upper Post (F) once you have them
aligned and tighten securely.
Hardware Used: 4 x Small Bolt w/Lock Washer
8. Install Reflector. NOTE: MAKE SURE TO REMOVE PROTECTIVE
PLASTIC COVER ON REFLECTOR PIECES PRIOR TO ASSEMBLY!
Assembly Tip: If necessary for proper alignment of reflector sections, loosen each
screw prior to further assembly and retighten after sections are aligned.
Slide two Reflector Panels (A) together. Insert one Small Screw.
Screw on Cap Nut loosely.
Repeat with the other Reflector Panels (A).
Slide Reflector Center Cap (B) onto assembled Reflector Panels (A). Insert
one Small Screw and screw on Cap Nut loosely. Repeat with two
more Small Screws and Cap Nuts to complete reflector assembly.
Fully tighten all screws and cap nuts.
Hardware Used: 12 x Small Screw
12 x Cap Nut
