7
1. Attach Wheel Assembly (K) to Base (J). Align holes in Wheel Assembly
with corresponding holes in Base, and insert 2 - Small Bolts through
holes and finger tighten. Be sure that Wheel Assembly is parallel to the
Base (J) and tighten with wrench.
Hardware Used: 2 x Small Bolt
*Optional sandbox: For models that come with a sandbox, the
sandbox will be pre-assembled to the base. To fill the sandbox,
remove the 4 Large Screws and Large Nuts that secure
the base to the sandbox. Pry open the plastic cap on top of the
sandbox and fill the sandbox with water or sand. Replace plastic
cap. Slide base back over the sandbox and align the holes in the
base with the holes in the sandbox. Insert bolts through holes in
base and secure by tightening nuts on ends of bolts. You may find
it easier to fill the sandbox prior to attaching wheels.
2. Attach the Post Supports (I) to the Base (J). Align the holes in the
bottom of each Post Support with the hole on the Base.
Insert 1 Small Bolt through the hole in the support
and into the Base and hand tighten. Repeat with the other
2 Post Supports and then tighten all bolts with a wrench.
Hardware Used: 3 x Small Bolt
