10
9. While supporting heater, tilt the Head Assembly (C) and slide
3 Large Flat Washers over the Reflector Studs. Place the
Reflector Assembly onto the Reflector Studs and slide 3 Large
Flat Washers over the Reflector Studs and onto the Reflector
Assembly. Secure with 3 Wing Nuts . Once you have tightened the
Wing Nuts, return the heater to an upright position.
Hardware Used: 6 x Large Flat Washer
3 x Wing Nut
10. Connect the hose and regulator to the LP cylinder. The
LP cylinder is sold separately. Use a standard 20 lb. propane
cylinder only. Lift the Tank Housing (D) up and rest it on the
top of the assembled Post Supports (I). Screw Regulator (H)
onto Gas Hose (E). Do not cross thread. Hand tighten securely
then tighten with a wrench. Attach Regulator (H) to valve on
LP cylinder and hand tighten securely. Place LP tank onto base
of heater. Secure the LPG tank by attaching the Chain (L) onto
the post supports. Lower the Tank Housing.
NOTE: Use this heater only with a propane vapor withdrawal
supply system. See chapter 5 of the standard for storage and
handling of liquefied petroleum gas, ANSI/NFPA 58. Your local
library or fire department should have this book.
