13
Lighting:
NOTE: For initial start or after any cylinder change, hold the control knob in for 2 minutes to purge air from all
gas lines before proceeding.
1. Turn the control knob to the “OFF” position.
2. Fully open the LP cylinder valve.
3. Push in and turn the control knob half way between the
HI and LO symbols.
4. Push control knob in and then push the RED igniter button
to ignite the main burner. Repeat until the burner ignites. Keep
the control knob fully pushed in for an additional 30 seconds after
the burner ignites, then release the control knob.
5. To increase the flame, turn the control knob clockwise towards
HI. To decrease the flame, turn the control knob counter clockwise
towards LO.
6. To turn the appliance OFF, push down the control knob and turn
clockwise to the OFF position.
7. Wait at least 5 minutes before attempting to re-light the heater.
8. Turn the gas cylinder valve to OFF or closed.
If you experience any ignition problems, please consult “Troubleshooting” on page 16.
Caution: Avoid inhaling fumes emitted from the heater’s first use. Smoke and odor
from the burning of oils used in the manufacturing will appear. Both smoke and
odor will dissipate after approximately 30 minutes. The heater should NOT produce
thick black smoke.
When Heater is ON:
Emitter screen will become bright red due to intense heat. The color is more visible at night. Burner will display
tongues of blue and yellow flame. These flames should not be yellow or produce thick black smoke, indicating an
obstruction of airflow through the burners. The flame should be blue with straight yellow tops. If excessive yellow
flame is detected, turn off heater and consult “Troubleshooting” on page 16.
Re-Lighting:
Note: For your safety, control knob cannot be turned OFF without first depressing the control knob and then
rotating to OFF.
1. Turn control knob to OFF.
2. Wait at least 5 minutes to allow gas to dissipate before re-lighting.
3. Repeat the “Lighting” steps listed above.
