A SERVICE OF

logo

Open as PDF
next previous
8
3. Attach the Lower Post (G) to the Post Supports (I). Once you
have tightened the bolts holding the Post Supports (I) to the Base (J),
align the holes in the Lower Post (G) with the holes on the tops
of the Post Supports (I) and insert a Large Bolt through the
hole in the Post Support. Secure with a Small Flange Nut. Repeat
this in the 5 remaining holes (6 holes total—2 for each Post Support
piece). Hand tighten initially then tighten with a wrench when all bolts
have been inserted.
Hardware Used: 6 x Large Bolt
6 x Small Flange Nut
4. Attach Upper Post (F) to Lower Post (G) by screwing the two pieces of the post
together.
5. Place Tank Housing (D) onto Base (J). Slide Tank Housing (D) over
the assembled Upper/Lower Post and down over the Post Supports.
Rest Tank Housing on Base.
ASSEMBLY
3
4
5