You can set the top-of-form position from 2.6 mm (0.1 inch)
to 33.9 mm (1.33 inch) below the top edge of the paper. The
factory setting is 5.8 mm (0.2 inch).
Follow the steps below to reset (permanently change) the
top-of-form position.
c
Caution:
To adjust the top-of-form position when labels are loaded in
the printer, use the forward-feeding (top) Micro Feed button
only; do not enter the top-of-form mode. (See “Adjusting the
printing position” later in this chapter.) Never feed labels
backward through the printer.
1. Make sure the printer is turned on and the desired tractor
is selected (the corresponding tractor arrow should be lit).
2. Open the top cover.
3. Press the TOF button to enter top-of-form mode. The printer
beeps once, and the TOF light flashes. Also, the printer
advances the paper so that the top-of-form position is lined
up with the red line on the clear plastic ribbon protector.
L
Peony Rev.C
A5 size Chapter 3
98/01/07 Pass 4
3-18
Paper Handling
