A SERVICE OF

logo

Open as PDF
next previous
2. Make sure paper is loaded on the front tractor to the
top-of-form position. If paper is already loaded on the
tractor but it is in the standby position, press the
Front/Rear or LF/FF Load button (depending on which
tractor is selected) to load the paper to the top-of-form
position. (If no paper is loaded on the front tractor, load
paper as described in Chapter 3.)
3. Once you have paper loaded on the printer’s front tractor,
use the LF/FF Load button to advance the paper to the pull
tractor.
4. Release both sprocket lock levers on the pull tractor by
pulling them toward you. Then open both sprocket covers.
5. Adjust the sprockets to match the width of your paper.
D-4-6
D-4-7-A
L
Peony Rev.C
A5 size Chapter 6
98/01/07 Pass 4
6-6 Using Printer Options