You must remove all protective materials packed around and
inside your printer before you set it up and turn on the power.
Follow the directions on the Notice Sheet to remove these
materials. A screwdriver has been included for removing the
transportation screw.
Save all packing and protective materials, including the
protective locking clips on the paper tension unit and the
transportation screw, in case you need to ship the printer
in the future. It should always be transported in its original
packaging, or equivalent materials.
c
Caution:
There are several versions of the printer designed for different
voltages, and it is not possible to adjust the printer for use at
another voltage. If the label on the back of the printer does not
show the correct voltage for your country, contact your dealer.
Choosing a Place for the Printer
When selecting a place to set up your printer, be sure to follow
these guidelines:
T Place the printer on a flat, stable surface, close enough to
the computer for the interface cable to reach it.
T Leave adequate room around the printer for easy operation
and maintenance.
T Avoid locations that are subject to direct sunlight, excessive
heat, moisture, or dust.
T Use a properly grounded electrical outlet; do not use an
adapter plug.
T Place the printer where you can easily unplug the power
cord.
L
Peony Rev.C
A5 size Chapter 1
98/01/07 Pass 4
1-4
Setting Up the Printer
