A SERVICE OF

logo

Open as PDF
next previous
Send documentation comments to mdsfeedback-doc@cisco.com.
2-9
Cisco MDS 9216 Switch Hardware Installation Guide
78-16165-01
Chapter 2 Installing the Cisco MDS 9216 Switch
Installing the Chassis in the Rack
To install the Cisco MDS 9216 Switch in a rack, follow these steps:
Step 1 Install the L brackets as follows:
a. Position an L bracket against the chassis and align the screw holes as shown
in Figure 2-1, then attach the L bracket to the chassis with six of the M4
screws.
b. Repeat with the other L bracket on the other side of the switch.
Figure 2-1 Attaching L Brackets to the Cisco MDS 9216 Switch
Step 2 Attach the C brackets to the sides of the chassis using two M4 flathead screws per
side (see Figure 2-2 and Figure 2-3).
1 L bracket 2 Screws, M4
M
D
S
9
216
94983
1
2