Filter
Top Products
To INSTALL standard alkaline batteries:
1. Open the BATTERY COMPARTMENT LID by moderately pushing down in an outward angle on the OPEN/CLOSE release
tab
2. Refer to the polarity diagram inside the battery compartment of the unit to view the (+) and (-) polarity markings
3. Install 10 "D" size alkaline batteries (not supplied) according to the polarity diagram
4. Replace the BATTERY COMPARTMENT LID
Battery Power and Recharging Operations
To RECHARGE Ni-Cd/Ni-MH batteries:
1. Connect the supplied POWER ADAPTER to the unit's DC input, and connect adapter to a compatible AC POWER
SOURCE.
2. Set the CHARGE/AC BATT IN toggle to CHARGE.
3. Charge for approximately 12 HOURS when the batteries are depleted.
NOTES:
It is important not to severely over-charge rechargeable batteries, as their ability to fully recharge and retain the
charge may be compromised. To avoid this, switch the CHARGE/AC BATT IN TOGGLE back to NORMAL or unplug the
POWER ADAPTER from the POWER SOURCE.
Never try to recharge standard alkaline batteries as they can leak acid and possibly explode.
Only recharge Ni-MH and Ni-Cd batteries.
It is recommended to only use the supplied power adapter for recharging operations, and to always avoid using a
power adapter that is not correctly matched for this unit and your power supply.
Open Close
6