Filter
Top Products
ViewSonic NMP-500 9 of 38
1 In the TV Mode field, click the down arrow for the pull-down menu and select one of the
resolutions required by your display (PDP or LCD).
2 Move the Brightness slider: values range between -128 and 127
3 Move the Contrast slider: values range between 0 and 255
4 Move the Saturation slider: values range between 0 and 255
5 Move the Audio Channel Volume (left) slider: values range between 0 and 100
6 Move the Audio Channel Volume (right) slider: values range between 0 and 100
7 If any changes were made to this screen, do the following:
• To enable the changes, click Apply
• To save the changes, click the Administration menu > click Save Configuration > click Save.
5. Put Batteries in Remote Control
Remove the back cover from the remote control as shown below. Put two AA batteries in
the battery compartment. Be sure to match the positive end of the battery with the positive
end in the compartment. Put the cover back on the remote control.