Filter
Top Products
6
Enter your own 2-digit time zone on the SimpleSet Keypad. For example if you live in the Pacific Time Zone enter “05” on the
keypad and then press the ENTER button. The clock will ‘beep’ twice and the time display will change from Eastern Time
to Pacific Time.
Note: You must always enter a zero (0) before your time zone number. If you do not enter a zero first you will hear a long
‘beep’ indicating that your time zone was not recognized. If this occurs just re-enter your 2-digit time zone correctly
according to the table above on page 5.
Date Display
To see the correct date at any time, depress the MONTH/DATE button. The display changes
from Time to Month and Date (MM/DD).
For example, October 9th will be displayed as 10. 9.
Year Display
To see the correct year, depress the MONTH/DATE and TIME buttons together.
The display changes from Time to Year.
Operating Instructions
Daylight Saving Time (DST) and Leap Year Adjustments
All Daylight Saving Time and Leap Year adjustments are made automatically by the Redi-Set internal computer as follows:
•
Start of Daylight Saving Time – At 2:00 AM on the 2
nd
Sunday in March the clock will automatically advance to 3:00 AM.
•
End of Daylight Saving Time – At 3:00 AM on the 1
st
Sunday in November the clock will automatically reset to 2:00 AM.
• Leap Year – At 12:00 midnight on February 28
th
in a Leap Year the calendar display will automatically change to “2.29”.
Note: If you live in an area that does not observe Daylight Saving Time (DST) you may disable the automatic Daylight Saving
Time (DST) feature. Depress and hold the TIME ZONE button for 5 seconds. The display will briefly show “OFF” and then
return to the correct time. The automatic DST feature is now disabled and the time will not change automatically from
Standard Time to Daylight Saving Time. Repeat this procedure again to re-enable the automatic DST feature.
Manual Time Adjustments
Some people like to set their clocks 5 to 10 minutes fast to make sure that they will always be ‘on time’. Even though the
Redi-Set internal computer sets the time automatically, you still have the option of adjusting the time manually if you wish.
To manually adjust the time display depress and hold the TIME button for 3 seconds until “0” begins flashing in the display.
While the “0” is flashing in the display enter the desired time on the SimpleSet keypad, press the AM/PM button if necessary
to switch between AM and PM, and then press the ENTER button. The clock will ‘beep’ twice to confirm that the setting was
accepted and the new time will appear on the display.
Note: If you manually adjust the time your new setting is entered into the Redi-Set internal computer as the new default time
setting. If the power is interrupted the display will return to your new setting, not the original setting, when the power is
restored.
P10