Filter
Top Products
42
Listening to the
Radio
1 Press RADIO ON•BAND to
turn on the radio.
2 Press RADIO ON•BAND
repeatedly to select AM or FM.
3 Press TUNING+/– to tune in
to the desired station.
If you keep pressing
TUNING+/– for a few
seconds, the Walkman will
start tuning to the stations
automatically.
To turn off the radio
Press p•RADIO OFF .
To improve the broadcast
reception
•For AM: The Walkman has a
built-in antenna. Reorient the
Walkman horizontally to obtain
optimum AM reception.
•For FM: Extend the cord of the
remote control, the aerial. If the
reception is still not good, press
MENU repeatedly to set the
cursor to FM MODE in the
display. Then press SET to show
“MONO” (monaural).
Note
•Do not remove the power sources
while listening to the radio, or the
received stations may not be stored.
Presetting Radio
Stations
Once you store your favorite
stations in memory, you can play
them easily. You can preset up to
8 stations for FM and 8 stations for
AM of each mode (Eur, Jpn, USA).
Tuning the Area
Manually (Manual Area
Call)
When you choose 1 to 8 or the JR
area number, the table of Area
number (factory preset) will
automatically store.
1 Press RADIO ON•BAND to
turn on the radio.
2 Press ENTER to flash the
frequency, PRESET and the
preset number in the display.
3 Hold down RADIO ON•
BAND until “AREA 1” will
flash in the display.
4 While “AREA 1” is flashing,
press PRESET+/– repeatedly
to select and area number from
1 to 8 or JR area number and
then press ENTER.
5 Press RADIO ON•BAND
repeatedly to select AM or FM
and then press PRESET+/– to
select a preset number you
wish to listen to.