Filter
Top Products
The Tape Player
The Tape Player
25
Tips
• If you made a mistake,
press CANCEL. The
track programed last
will be cleared. Re-
program it.
• To check the order of
tracks, press
PROGRAM•AUTO
PRESET•CHECK in
stop mode until
“CHECK” appears in
the display. Press
= or + to display
the track number in the
programmed order.
• To check the total
recording time on the
front side and the
reverse side:
Press DISPLAY
ENTER MEMORY
before starting
recording. Each time
you press the button,
the display changes as
follows: “total
recording time on the
front side”
n
“total
recording time on the
reverse side”
n
“total
track number and the
tape length you need
to record the whole
CD.
3 Press = or + to select the track you want to
program, and press DISPLAY ENTER MEMORY.
The total number of programed tracks and the
minimum tape length (unit: 2 minutes, up to 98
minutes) you need to record the programed tracks
appear in the display.
4 Repeat step 3.
5 To change the recording time, press DISPLAY
ENTER MEMORY.
If you do not change the recording time, skip to
step 7.
Tape length flashes.
6 Press = or + to change the recording time
and press DISPLAY ENTER MEMORY.
7 Insert a blank tape into the tape compartment.
8 Press r/P and then (.
Recording will start on the front side automatically.
The tracks are recorded in the programed order.
Note
When “--” is displayed
as the tape length, the
total recording time of
the programed tracks
exceeds 98 minutes.
Start from step 1 again.