Filter
Top Products
64-GB
Messages
If the following messages flash in the display window, check the messages below.
Error message Meaning/Remedy
BLANK • An MD with no recording on it is inserted.
BUSY • You tried to operate the recorder while it was accessing the recorded
data.
, Wait until the message goes out (in rare cases, it may take a few
minutes).
Saving • The MD player is recording information (sounds) from the memory
to the disc.
, Wait until this process is completed. Do not expose the player to
any physical shock, nor disrupt power supply.
ERROR • Recording was not correctly done.
, Place the recorder at a place with no vibrations and record again.
• The disc is soiled with an oil film or finger prints, is scratched, or is
not a standard disc.
, Try recording again with another disc.
• The recorder cannot read the disc information correctly.
, Reinsert the disc.
• The recorder cannot read the disc information correctly.
, Insert another disc.
, If it is no problem to erase the entire disc, do so (page 46).
FULL • The remaining recording time on the disc is 12 seconds (stereo), 24
seconds (LP2 stereo or monaural), 36 seconds (LP4 stereo), or less.
, Replace the disc.
HiDCin • Voltage of the power supply is too high (The supplied AC power
adaptor or the recommended car battery cord is not used).
, Use the supplied AC power adaptor or the recommended car
battery cord.
HOLD • The recorder is locked.
, Slide HOLD against the arrow to unlock the recorder (page 14,
49).
LoBATT • Battery is weak.
, Charge the rechargeable battery or replace the dry battery
(page 13).
MEMORY • You tried to record with the recorder placed where it receives
continuous vibration.
, Put the recorder on a stable place, and start recording again.