Filter
Top Products
38-GB
Editing recorded tracks
You can edit your recordings by adding/
erasing track marks or labeling tracks and
MDs. Premastered MDs cannot be edited.
Notes on editing
• You cannot edit tracks on an MD that is
record-protected. Before editing tracks, close
the tab on the side of the MD (page 52).
• If you perform an editing operation while
playing, be sure not to turn the power off until
“Edit” disappears in the display.
• Do not move the recorder while “Edit”* is
flashing in the display.
• The lid will not open until “Edit” disappears
in the display after editing.
• When group mode is on, editing can be
performed only for the tracks registered into
the selected group.
When you operate the recorder with the
supplied remote control, use the buttons
and controls shown in parentheses.
Labeling/relabeling
recordings
You can name tracks, groups and discs
using the recorder’s character palette.
Available characters
• Capital and small letters of the English
alphabet
• Numbers 0 to 9
• ! " # $ % & ( ) * . ; < = > ?
@ _ ` + – ' , / : _ (space)
Numbers of characters you
can input
Track, group, or disc name: Approx. 200
each
Numbers of characters you
can input in a disc
Numbers/marks: Approx. 1,700
Notes
• “FULL” appears when you try to enter more
than 1,700 characters on a disc. Enter a shorter
name for the track, group, or disc, or set the
“LPStmp” setting to “OFF” when recording in
MDLP mode so that “LP:” is not be added at
the beginning of the track name (page 26).
• When labeling a disc which has been recorded
using the group function, make sure group
mode is on in order to prevent the group
management information from being
overwritten by mistake.
• If you enter the symbol “//” between the
characters in disc names such as “abc//def”,
you may be unable to use the group function.
T MARK
ENTER
EDIT
MENU/
ENTER
>/.
DELETE
VOL +/–
CAPS
VOL +/–
END SEARCH
GROUP/
CANCEL
X
./>/x