Filter
Top Products
60
GB
Symptom
You cannot
add a recording or an
overwrite recording.
Recording is
interrupted.
Noise is heard.
Recording level is
low.
Recording level is
unstable (when
recording music, etc.).
Recording is
interrupted (when
recording from an
external device).
Remedy
•The remaining memory is too short. The
overwritten part will be deleted after the
overwriting part finishes recording. Therefore,
you can only overwrite within the remaining
recording time.
•At a factory setting, REC-OP is set to OFF.
Display the menu and set the REC-OP to ON
(page 52) .
•The advanced VOR function (page 15) is
activated. Set the VOR to OFF.
•An object, such as your finger, etc., accidentally
rubbed or scratched the unit during recording
so that noise was recorded.
•The unit was placed near an AC power source,
a fluorescent lamp or a mobile phone during
recording or playback.
•Plug of the connected microphone was dirty
when recording. Clean the plug.
•The i (headphones) plug is dirty. Clean the
plug.
•SENS (microphone sensitivity) is set to L.
Display the menu and set SENS to H (page 54).
•If it is difficult to hear small sound of a
recorded message, slide VOICE UP to ON.
Playback sound may become more audible.
•This unit is designed to automatically adjust
the recording level when recording meetings,
etc., and is not suitable for music recording.
•If you use an audio connecting cable without
register to connect the sound source to the IC
recorder, sound may be recorded interrupted.
Make sure to use a registered audio connecting
cable.
Troubleshooting (continued)