10
GB
Additional Information
Specifications
System
Type Active Super Woofer and Passive Center
Speaker
Speaker unit Woofer: 13 cm × 2 (5
1
/8 inches × 2)
Centre: 8 cm × 2 (3
1
/4 inches × 2), 8 Ω,
maximum input level 100 W
Practical maximum super woofer output
55 W
Reproduction frequency range
20 Hz – 200 Hz
High frequency cut off frequency
50 Hz – 150 Hz
Phase switch NORMAL/REVERSE
Inputs/Outputs
LOW LEVEL Pin jacks, 2 channels, with loopthrough
outputs.
HIGH LEVEL INPUT/OUTPUT speaker jacks
General
Power requirements
220-240 V AC, 50/60Hz
Power consumption
120 W
Dimensions Approx. 920 x 266 x 534 mm (w/h/d)
(36
1
/4 × 10
1
/2 × 21
1
/8 inches)
Mass 24 kg (52 lb 15 oz)
Supplied accessories
Audio connecting cord
(2 phono plugs - 2 phono plugs) (1)
Clip (1)
Screw (1)
Design and specifications are subject to change without
notice.
Troubleshooting
If you experience any of the following difficulties while
using the speaker system, use this troubleshooting
guide to help you solve the problem. Should any
problem persist, consult your nearest Sony dealer.
There’s no sound.
/ Check that this speaker system and other
components are connected correctly and
securely.
/ Turn the VOLUME control clockwise to turn
the volume up.
The sound has suddenly stopped.
/ The speaker cords may have short-circuited.
Connect the cords properly.
The sound is distorted.
/ The input signal is not clear.
/ The input signal level is too high.
Severe hum or noise is heard.
/ Connect the ground wire of the turntable
properly.
/ The contacts between the plugs of the
connecting cords and the corresponding jacks
have not been made properly. Connect the
plugs firmly.
/ The audio system is picking up some noise
from the KL-50W series TV set. Turn the TV set
off.