Filter
Top Products
NWD-B103 / B105 / B103F / B105F. GB. 3-210-125-14(1)
56
57
NWD-B103 / B105 / B103F / B105F. GB. 3-210-125-14(1)
Other
Symptom Cause/Remedy
There is no beep sound when the
player is operated.
• “Beep” is set to “Beep OFF.”
Set “Beep” to “Beep ON” (
page 41).
The beep sound level varies. • The beep sound level varies according to the current volume of
the player.
The player gets warm. •
The player may be warm when the battery is being charged and just
after charging. The player also may get warm when a large amount
of files are transferred. This is normal and is not cause for concern.
Set the player aside for a while to allow it to cool down.
The date and time have been
reset.
• If you left the player for a while with the battery used up, the
date and time may be reset.
This is not a malfunction. Charge the battery until
appears on the screen (
page 12) and set the date and time
again (
page 41).
All settings of the player have
been reset.
• You moved, deleted, or renamed the system files. Or, the built-in
flash memory of the player was formatted using other than the
“Format” menu of the player.
If you do any of the above operations, the system will be
restructured and all settings of the player will be reset when
you disconnect the player from the computer or other devices.
If the player does not function normally after you format the
player using other than the “Format” menu of the player,
format the built-in flash memory using the “Format” menu of
the player (
page 42).
To initialize (format) the player
Be sure to format the built-in flash memory using the “Settings” menu on this
player following the procedure below. (Check all contents before formatting as all
data stored will be erased.)
1 Press and hold the BACK/HOME button until the HOME menu
appears.
2 Select (Settings) – “Format” – “OK,” in this order.
Press the / button to select the item, and then press the button to
confirm.
After selecting “OK” and confirming, “FORMATTING…” appears and
formatting starts. When formatting is complete, “COMPLETE” appears.
Messages
Follow the instructions below if a message appears in the display.
Message Meaning Remedy
AVLS (blinks) The volume level exceeds the
rated value while
“AVLS(Volume Limit)” is
enabled.
Turn the volume down or disable
“AVLS(Volume Limit)” (
page 41).
CHARGING The battery is being charged. This is not an error. Wait until the battery is
charged fully. However, you can use the
player with the battery not charged fully.
Troubleshooting (continued)
Continued
Troubleshooting